Battery matching without code
What is the Battery Matching Function of the OBD Scan Tool? This function enables you to perform a resetting operation on the monitoring unit of vehicle battery, in which the original low battery fault information will be cleared and battery matching will be done. Battery matching must be performed in the following. . If the battery is not matched, the ECU does not recognize it as new and continues to drive the charging cycle as if it were the old battery. This reduces fuel economy and significantly. [pdf]
FAQS about Battery matching without code
Do aftermarket batteries have a valid part number?
Aftermarket batteries may NOT have a valid Part Number, Vendor code or Serial number. Ross-Tech cannot offer assistance if the necessary information is missing. This procedure applies to battery replacement in vehicles using a separate battery management control module. Address 61: Battery Regul.
How do I fix a non Bem coded battery?
As per their own instructions for non BEM coded batteries I changed only the final digit on the battery serial code, and updated the manufacturer to VAO (Varta). Cleared the Battery management error code (on the same screen) and monitored it for 48 hours and all good holding 12.7v when off.
What is the correct coding type for AGM batteries?
The correct coding type for AGM batteries is "fleece" and not "binary AGM", as that is a different type of battery altogether. Pretty much the manufacturer coding does not matter. But as long as the serial number is changed by 1 digit and the battery has the correct AH rating plus it coding as fleece you will be fine.
What is 61-battery regulation & adaptation Channel 004?
In these cases, the new battery information is entered in 61-Battery Regulation then Adaptation Channel 004. This procedure applies to battery replacement in vehicles using a battery management control module that is a slave/subsystem of the CAN Gateway. Part No SW: 8T0 907 468 Q HW: 8T0 907 468 L
When should a battery pack be balanced?
Assuming the battery pack will be balanced the first time it is charged and in use. Also, assuming the cells are assembled in series. If the cells are very different in State of Charge (SoC) when assembled the Battery Management System (BMS) will have to gross balance the cells on the first charge.
Can a cell manufacturer assemble and charge without gross balancing?
1. Supplier Delivers Matched Cells If the cell manufacturer can deliver cells with a proven quality history of OCV within +/-0.02V then you will be able to assemble and charge these cells without gross balancing. What is measured at Cell manufacturing end of line should be remeasured at Goods receipt.
Contact Us
We are deeply committed to excellence in all our endeavors.
Since we maintain control over our products, our customers can be assured of nothing but the best quality at all times.